For years I have been doing wheel alignments. I have used magnetic gauges that stick to the spindle or wheel hub end. But I just invested in a set of used commercial wheel alignment clamps that have a disk my magnetic gauges will stick to now. But these clamps have three adjustments on the disks to get them parallel with the wheel. What is the down and dirty way to make that adjustment on those three little screws? I'm thinking maybe the wheel is turned and adjusted but I can't find any instructions on how this is done correctly. I'm sure there are some wheel alignment pro's here that will have the answer or at least where I could download the instructions so I'm asking the experts for help.
Thank you in advance gentlemen for your advice and help here.
Lisa
