« previous next »
Pages: [1]   Go Down

Author Topic: Ames gauge mount  (Read 2486 times)

0 Members and 1 Guest are viewing this topic.

Online skipskip

  • Contributor
  • Hero Member
  • *****
  • Posts: 1516
  • Glenmont NY USA
Ames gauge mount
« on: September 30, 2012, 03:02:27 PM »
Not so much a what is it, but a how is it used.


SEP 507 by skipskip, on Flickr


I know who Ames is, and I know what a gauge mount might do, but how does this one work?

Skip
Logged
A place for everything and everything on the floor

Offline mikeswrenches

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 2002
Re: Ames gauge mount
« Reply #1 on: September 30, 2012, 04:01:08 PM »
Kind of looks like the old magnets we played with when I was a kid.

Mike
Logged
Check out my ETSY store at: OldeTymeTools

Offline Billman49

  • Hero Member
  • *****
  • Posts: 790
  • Collector of edged tools, especially billhooks...
    • A Load of Old Billhooks
Re: Ames gauge mount
« Reply #2 on: September 30, 2012, 04:31:06 PM »
Ames made a variety of dial gauges, I guess as some of them have steel or cast iron frames, this could be used to hold them in a vertical plane, e.g on a surface plate or part of a machine...
« Last Edit: September 30, 2012, 04:33:53 PM by Billman49 »
Logged

Offline oldtools

  • Hero Member
  • *****
  • Posts: 1424
  • Keep OldTools alive by giving them a purpose
Re: Ames gauge mount
« Reply #3 on: September 30, 2012, 05:26:58 PM »
Seen similar magnetic base to hold height gauge to a surface plate, but I haven't seen one like yours.
no threaded holes to hold dial indicator rods?
Logged
Aloha!  the OldTool guy
Master Monkey Wrench Scaler

Online skipskip

  • Contributor
  • Hero Member
  • *****
  • Posts: 1516
  • Glenmont NY USA
Re: Ames gauge mount
« Reply #4 on: September 30, 2012, 06:18:26 PM »
Quote from: oldtools on September 30, 2012, 05:26:58 PM

no threaded holes to hold dial indicator rods?

nope, just a plain horseshoe magnet about 4 1/2 inches long
Logged
A place for everything and everything on the floor

Offline EVILDR235

  • Hero Member
  • *****
  • Posts: 1323
Re: Ames gauge mount
« Reply #5 on: September 30, 2012, 06:32:10 PM »
It looks like a Ford Model T magneto magnet. I have several with the Ford logo on them.

EvilDr235
Logged

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Ames gauge mount
« Reply #6 on: September 30, 2012, 08:31:24 PM »
> Model T magneto magnet

I thought it looked familiar....

They show up at the flea every once in a while...

Probably available cheap, all you need to fasten a guage to it is a bolt through the V end with a washer and nut on each end....
Logged
Just a weathered light rust/WD40 mix patina.
Pages: [1]   Go Up
« previous next »