« previous next »
Pages: [1]   Go Down

Author Topic: Selector switch for Western auto 1/2" ratchet  (Read 4580 times)

0 Members and 1 Guest are viewing this topic.

Offline crankshaftdan II

  • Hero Member
  • *****
  • Posts: 285
Selector switch for Western auto 1/2" ratchet
« on: March 10, 2012, 08:36:29 AM »
.268 dia. across the flat of the hex x 1" or 1 1/8" in length-close to the one in the picture-this is NOT a prom queen ratchet so just looking for something close to make it work.  Thanks for viewing...........Cranky
Logged
E-mail address  dhdslimbow@yahoo.com
Looking for USA made ratchets-all sizes-drives and lengths  also S-K SuperKrome wrenches ditto.  Like to trade vs buy run it past me-nothing is cut in stone!

Offline scottg

  • Hero Member
  • *****
  • Posts: 1748
    • Grandstaffworks Tools
Re: Selector switch for Western auto 1/2" ratchet
« Reply #1 on: March 10, 2012, 05:03:21 PM »
Sure like that model Cranky!! The handle looks like it'd just settle into a hand!
 
 Me, I'd just make one.
  Not sure how long it takes you to post a picture, but if it was me?
 Would have grabbed me a scrap off the bench and been done by now.
 yours Scott
 
Logged
Pages: [1]   Go Up
« previous next »