« previous next »
Pages: [1]   Go Down

Author Topic: difference between vlchek wba and wbh?  (Read 2263 times)

0 Members and 3 Guests are viewing this topic.

Offline Steve-o

  • Sr. Member
  • ****
  • Posts: 59
difference between vlchek wba and wbh?
« on: December 27, 2011, 12:33:31 AM »
I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve
Logged
It is what it is.

Offline kxxr

  • Hero Member
  • *****
  • Posts: 1157
Re: difference between vlchek wba and wbh?
« Reply #1 on: December 27, 2011, 06:10:16 AM »
Check here for details if you haven't already. I run into both kinds fairly often.
http://home.comcast.net/~alloy-artifacts/vlchek-story-p2.html
Logged

Offline bonneyman

  • Hero Member
  • *****
  • Posts: 1743
Re: difference between vlchek wba and wbh?
« Reply #2 on: December 27, 2011, 01:46:16 PM »
Vlchek DBE's. I likey!
Logged
Ratchet Guru

Offline eddie hudson

  • Hero Member
  • *****
  • Posts: 3619
  • NYC
Re: difference between vlchek wba and wbh?
« Reply #3 on: December 27, 2011, 02:15:23 PM »
Quote from: Steve-o on December 27, 2011, 12:33:31 AM
I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve

Aren't the offsets different?
Logged

Offline kxxr

  • Hero Member
  • *****
  • Posts: 1157
Re: difference between vlchek wba and wbh?
« Reply #4 on: December 27, 2011, 07:39:38 PM »
Quote from: eddie hudson on December 27, 2011, 02:15:23 PM
Quote from: Steve-o on December 27, 2011, 12:33:31 AM
I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve

Aren't the offsets different?
That's what I would guess, with the 'A' being deep (45 degrees) offset and 'H' much less and with either a raised panel or a flat panel.
Logged
Pages: [1]   Go Up
« previous next »