« previous next »
Pages: [1]   Go Down

Author Topic: Plomb Question  (Read 1986 times)

0 Members and 1 Guest are viewing this topic.

Offline t115145

  • Sr. Member
  • ****
  • Posts: 114
Plomb Question
« on: April 14, 2017, 08:34:20 AM »
Did Plomb ever make an 11/32 combination "pebble" wrench?
Logged

Offline mikeswrenches

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 2002
Re: Plomb Question
« Reply #1 on: April 14, 2017, 10:07:32 AM »
Take a look at the Tool Archives web site. Todd has posted a bunch of Plomb catalogs that you can download and then look through. I went through a couple of them and didn't see an 11/32.

Mike
Logged
Check out my ETSY store at: OldeTymeTools

Offline Northwoods

  • Hero Member
  • *****
  • Posts: 1901
Re: Plomb Question
« Reply #2 on: April 14, 2017, 11:30:33 AM »
Sheesh!  I'd be happy to find one in 3/8.  I can find everything else, but no 3/8.
Logged
The ORIGINAL Northwoods.

Offline t115145

  • Sr. Member
  • ****
  • Posts: 114
Re: Plomb Question
« Reply #3 on: April 14, 2017, 05:32:36 PM »
Northwoods,
Pretty sure I've seen 3/8ths on craigslist or Ebay.  It might have been with a junk-drawer clean out.
Logged

Offline Bad 31

  • Sr. Member
  • ****
  • Posts: 86
Re: Plomb Question
« Reply #4 on: April 14, 2017, 06:46:36 PM »
And I'm sitting here holding a 3/8" pebble that a friend just sent me from the west coast. Must be my lucky day.
Logged

Offline EVILDR235

  • Hero Member
  • *****
  • Posts: 1323
Re: Plomb Question
« Reply #5 on: April 14, 2017, 08:56:40 PM »
After I saw this post, I went and checked my hoard. I just sent one to a friend down South.

EvilDr235
Logged

Offline Northwoods

  • Hero Member
  • *****
  • Posts: 1901
Re: Plomb Question
« Reply #6 on: April 14, 2017, 10:18:13 PM »
Grrrrrr....
Logged
The ORIGINAL Northwoods.
Pages: [1]   Go Up
« previous next »