« previous next »
Pages: [1]   Go Down

Author Topic: Craftsman boxed end wrench  (Read 884 times)

0 Members and 1 Guest are viewing this topic.

Offline toolmiser

  • Full Member
  • ***
  • Posts: 49
Craftsman boxed end wrench
« on: November 14, 2016, 05:59:32 PM »
Found this at a garage/estate sale.  No markings other than "Craftsman".  I was hoping it would fit the arbor nut  on my table saw, but it's too big.  Any idea what the original purpose was? 

Thanks

Logged

Offline p_toad

  • Hero Member
  • *****
  • Posts: 955
Re: Craftsman boxed end wrench
« Reply #1 on: November 14, 2016, 08:11:02 PM »
Tighten or loosen some nut?   :tongue:

The nut on my old sears saw is a 1 1/16" if i recall right..
Logged
Pages: [1]   Go Up
« previous next »