« previous next »
Pages: [1]   Go Down

Author Topic: ??W & CO  (Read 2257 times)

0 Members and 1 Guest are viewing this topic.

Offline Neals

  • Contributor
  • Hero Member
  • ***
  • Posts: 745
  • Alberta, Canada
??W & CO
« on: July 17, 2012, 05:35:49 PM »
I should know this but am drawing a blank. Stamped on the end is ??W & CO. Below that is ?? USA. Also on the shaft is a triangle with an M inside or a W depending on which way you look at it. (Mossburg or Moore?) Sides on the M are straight not curved. Also marked 530. 3/8" x 1/2 " and 5 3/4 " long.
Logged

Offline lbgradwell

  • Hero Member
  • *****
  • Posts: 1491
  • Oakville, ON
Re: ??W & CO
« Reply #1 on: July 17, 2012, 05:46:24 PM »
Any chance of a shot of the logo? Failing that, is it an M or a W when holding the 3/8" end up?
Logged

Kijiji King

Offline Neals

  • Contributor
  • Hero Member
  • ***
  • Posts: 745
  • Alberta, Canada
Re: ??W & CO
« Reply #2 on: July 17, 2012, 05:50:31 PM »
Couldn't get a decent shot of the logo or stamping. With 3/8 end up its a W and the long side of the diamond is horizontal
Logged

Offline lbgradwell

  • Hero Member
  • *****
  • Posts: 1491
  • Oakville, ON
Re: ??W & CO
« Reply #3 on: July 17, 2012, 06:05:30 PM »
Sounds like a JH Williams logo, but it doesn't look like a JH Williams wrench...

Don't you have a "macro" setting on your camera?
Logged

Kijiji King

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: ??W & CO
« Reply #4 on: July 17, 2012, 06:18:11 PM »
Any chance the triangle / diamond has a T W in it?
Logged
Just a weathered light rust/WD40 mix patina.

Offline Neals

  • Contributor
  • Hero Member
  • ***
  • Posts: 745
  • Alberta, Canada
Re: ??W & CO
« Reply #5 on: July 17, 2012, 10:29:20 PM »
No T. Making is clear
Logged

Offline wvtools

  • Contributor
  • Hero Member
  • ***
  • Posts: 981
Re: ??W & CO
« Reply #6 on: July 17, 2012, 10:54:32 PM »
It is a Williams set screw wrench.  The 1960 catalog has those sizes for the No. 530 double head set screw wrench.
Logged
Pages: [1]   Go Up
« previous next »