Author Topic: Thickness planer rebuild project (Read 5972 times)

Carl · « **on:** January 03, 2012, 06:47:52 PM »

Papaw · « **Reply #1 on:** January 03, 2012, 07:26:54 PM »

Moving this to Woodworking.

Nice job there!

Fins/413 · « **Reply #2 on:** January 04, 2012, 07:16:42 AM »

Well done I like the JB weld idea.

lazyassforge · « **Reply #3 on:** January 04, 2012, 08:02:03 AM »

Good Job, Carl!

Carl · « **Reply #4 on:** January 04, 2012, 08:06:39 PM »

Thanks. The JB Weld was my friends idea. I wanted to mill the whole casting down, but this was way easier.

johnsironsanctuary · « **Reply #5 on:** January 04, 2012, 08:52:22 PM »

What on earth could you put through it that would gouge the table like that and not totally demolish the cutting heads?
JIS

Carl · « **Reply #6 on:** January 05, 2012, 08:31:53 AM »

What on earth could you put through it that would gouge the table like that and not totally demolish the cutting heads?
JIS

Beats me- I bought it used like that. The blades weren't bad- I had them sharpened at a local lumberyard.

News: