« previous next »
Pages: [1]   Go Down

Author Topic: Unknown Quick Adjust Wrench  (Read 2039 times)

0 Members and 1 Guest are viewing this topic.

Offline Lewill2

  • Hero Member
  • *****
  • Posts: 1988
  • Bucks County PA
Unknown Quick Adjust Wrench
« on: December 18, 2011, 07:16:45 AM »
Did anybody ever see this one before? I haven't located anything on it yet. The only markings on it is "118" stamped on both the main body and the moveable jaw.
Logged

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Unknown Quick Adjust Wrench
« Reply #1 on: December 18, 2011, 11:40:41 AM »

Never seen that kind of mechanism before, does it have teeth under the bottom jaw? or does it cam?
Logged
Just a weathered light rust/WD40 mix patina.

Offline Lewill2

  • Hero Member
  • *****
  • Posts: 1988
  • Bucks County PA
Re: Unknown Quick Adjust Wrench
« Reply #2 on: December 18, 2011, 02:39:00 PM »
There is a spring directly below the lower jaw and the teeth that lock the lower jaw in position are on the back side of the lower jaw and main bar assembly. The teeth are real fine. The pin in the main bar just below the lower jaw slide piece keeps the lower jaw from coming off the main bar.
Logged

Offline jimwrench

  • Contributor
  • Hero Member
  • ***
  • Posts: 1803
Re: Unknown Quick Adjust Wrench
« Reply #3 on: December 18, 2011, 04:36:16 PM »
 Lew, Looks very much like Henry Boker (Schultz 776) except wrench in Schultz has hang hole. Hang hole could have been added.
Logged
Jim
Mr. Dollarwrench

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Unknown Quick Adjust Wrench
« Reply #4 on: December 18, 2011, 05:00:52 PM »
Logged
Just a weathered light rust/WD40 mix patina.
Pages: [1]   Go Up
« previous next »