« previous next »
Pages: [1]   Go Down

Author Topic: Machining section  (Read 1828 times)

0 Members and 1 Guest are viewing this topic.

Offline Carpenter84

  • Full Member
  • ***
  • Posts: 40
Machining section
« on: July 04, 2018, 01:45:14 PM »
Can we start a small machining section on the forum for us MG folk who are still feeling a bit outta place? Perhaps?
Logged

Offline Papaw

  • Owner/Administrator
  • Moderator
  • Hero Member
  • *****
  • Posts: 11221
  • Alvin, Texas
    • Papawswrench
Re: Machining section
« Reply #1 on: July 04, 2018, 01:48:19 PM »
I don't mind at all.
Logged
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
 
 Flickr page- https://www.flickr.com/photos/nhankamer/

Offline Spartan-C

  • Sr. Member
  • ****
  • Posts: 89
Re: Machining section
« Reply #2 on: July 04, 2018, 01:52:10 PM »
Cool!  Thanks Papaw!

Ken
Logged
Ken

Offline Spartan-C

  • Sr. Member
  • ****
  • Posts: 89
Re: Machining section
« Reply #3 on: July 04, 2018, 01:55:38 PM »
Say Shawn, there is a section I'm sure Papaw won't mind us posting in.

It's the "Blacksmith and Metalworking" forum.

Ken
Logged
Ken

Offline Papaw

  • Owner/Administrator
  • Moderator
  • Hero Member
  • *****
  • Posts: 11221
  • Alvin, Texas
    • Papawswrench
Re: Machining section
« Reply #4 on: July 04, 2018, 01:56:43 PM »
I have set up a Machinist Forum for those who wish to post there.
Logged
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
 
 Flickr page- https://www.flickr.com/photos/nhankamer/

Offline Spartan-C

  • Sr. Member
  • ****
  • Posts: 89
Re: Machining section
« Reply #5 on: July 04, 2018, 01:57:50 PM »
Never mind, he set up one for us.  Again thanks, Ken
Logged
Ken

Offline Carpenter84

  • Full Member
  • ***
  • Posts: 40
Re: Machining section
« Reply #6 on: July 04, 2018, 03:39:08 PM »
Stellar. Thank you.
Logged

Offline EVILDR235

  • Hero Member
  • *****
  • Posts: 1323
Re: Machining section
« Reply #7 on: July 04, 2018, 10:06:18 PM »
Thank you Papaw. I watch lots of machine shop stuff on Youtube. I hope to own a small metal turning lathe some day. I have reclaimed about half of my garage now.

EvilDr235
Logged
Pages: [1]   Go Up
« previous next »