Herbrand special tool and another what's it

[amecks]

This is a Herbrand 260 tool with pointed end and a round notched end for turning? what?

This looks familiar but I just can't figure out what or why...the bands are apparently a spring steel.  The very end (left) is a hex shape. No markings.

Thanks for looking
Al

[Papaw]

The second one could be a reamer.

[Spartan-C]

Or smoothing out the valve guides after knurling.  Dad had one similar but with round stiff wires in a helix.

Ken

[Ken W.]

The top pic looks kind of brake toolish.

[bill300d]

Chrysler brake spring tool in 1960 catalog.
and the other is a valve guide reamer.

[Papaw]

I should have been more specific I have used valve guide reamers in the past.

[amecks]

Thanks guys!  The reamer looks like something I might be able to use, the brake tool not so much.
Al

[Bill Gruby]

The second one could be a reamer.

 With all due respect "Papaw the second one looks like a Hone. What ysa think??

 "Billy G"

[Papaw]

Hone- Reamer- OK, I guess I have to agree a bit.

[EVILDR235]

I say the second one is to remove carbon from valve guides.

EvilDr235

[slip knot]

I'm not seeing the valve guide ream/hone thing... way too big for a valve guide hole.

BUT I cant tell what it actually is either.

[bill300d]

I looked it up and the Plomb version is called a valve guide cleaner. I'm sure that other Co's have other names for them but EVILDR is correct in calling it a carbon remover.

[amecks]

Yep.  Checked it last night and it adjusts!  The 1/4" hex on the tip expands the blades.  Thanks all!
Al

[slip knot]

I'll be. all that fits in a valve guide.