Author Topic: 1"-14 NS Tap  (Read 2359 times)

0 Members and 1 Guest are viewing this topic.

Online lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3065
1"-14 NS Tap
« on: March 24, 2018, 03:56:06 PM »
Hello, I have been trying to fill in a large Tap & Die Set.I have been looking for a 1"-12 NF Bolt Tap for a while. But today I looked at the list of contents to the set, and it calls for a 1"-14 NS Bolt Tap. Is that an unusual size? Thanks, Lou
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline leg17

  • Hero Member
  • *****
  • Posts: 641
Re: 1"-14 NS Tap
« Reply #1 on: March 24, 2018, 06:53:27 PM »
Both sizes have such widespread application that there never has been enough pressure to finally eliminate one.
If you want to be covered, better get them both.

Online lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3065
Re: 1"-14 NS Tap
« Reply #2 on: March 24, 2018, 07:20:00 PM »
Hello, Thanks for the info. That is what I will do, include both. Thanks again, Lou
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline leg17

  • Hero Member
  • *****
  • Posts: 641
Re: 1"-14 NS Tap
« Reply #3 on: March 24, 2018, 08:20:50 PM »
Be sure to double check any application.
I have seen expensive mistakes made when 'assuming' which one was correct.
Confirm the bolt or whatever before tapping the hole.
Seriously.

Offline Spartan-C

  • Sr. Member
  • ****
  • Posts: 89
Re: 1"-14 NS Tap
« Reply #4 on: June 11, 2018, 07:47:24 PM »
Yeah, 1"-14 UNF has pretty much surpassed 1"-12 NF in recent years.  I know I use 1"-14 UNF on a lot of equipment I design today.
Ken