« previous next »
Pages: [1]   Go Down

Author Topic: One for The Machinists On Here  (Read 2548 times)

0 Members and 1 Guest are viewing this topic.

Offline MysteriousGT

  • Sr. Member
  • ****
  • Posts: 101
One for The Machinists On Here
« on: May 31, 2013, 04:23:30 PM »
Some Special Machinst Bit i Found today!

Only Markings are (1 DIV.=.0001 ON Dia.

Has a Measuring Wheel that Doesnt Look like it Does anything But Spin around the Bit...It Doesnt Adjust anything Like Micrometers Do...Almost Looks like it Is Meant to Go In a Chuck/Drill

Its Aprox 5 1/4" Long and 1 3/4" In Diameter!

Any Idea What This is Used for?

Thanks
« Last Edit: May 31, 2013, 07:05:50 PM by MysteriousGT »
Logged

Offline superzstuff

  • Sr. Member
  • ****
  • Posts: 194
Re: One for The Machinists On Here
« Reply #1 on: May 31, 2013, 09:27:24 PM »
Small boring head for mill or jig borer. Single edge tool clamps in end and other end goes in collet not chuck. Chuck will damage shaft. Hole is drilled undersize and then boring head tool is moved out with graduated dial. 
Logged
38 years a Tool and Die maker, forever a collector!

Offline MysteriousGT

  • Sr. Member
  • ****
  • Posts: 101
Re: One for The Machinists On Here
« Reply #2 on: June 04, 2013, 12:13:14 PM »
Quote from: superzstuff on May 31, 2013, 09:27:24 PM
Small boring head for mill or jig borer. Single edge tool clamps in end and other end goes in collet not chuck. Chuck will damage shaft. Hole is drilled undersize and then boring head tool is moved out with graduated dial.

Thanks for the ID
Logged
Pages: [1]   Go Up
« previous next »