« previous next »
Pages: [1]   Go Down

Author Topic: From a machinist's box  (Read 1351 times)

0 Members and 1 Guest are viewing this topic.

Offline lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3180
From a machinist's box
« on: July 06, 2018, 06:48:59 PM »
Hello, This was found in a machinist's box. Any idea of what it would have been used for, or, part of? Thanks, Lou
Logged
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline Spartan-C

  • Sr. Member
  • ****
  • Posts: 89
Re: From a machinist's box
« Reply #1 on: July 06, 2018, 07:21:20 PM »
Looks like something I made 30 years ago and forgot all about it.  How did you get it?

Seriously, it's to someone's project and never did finish it, or could be a spare, or a scraped part that didn't pass inspection.

Looks like it has a couple of bearing journals for ball bearings, some kind of pulley attached to the middle and end.  Just a WAG.

Ken
Logged
Ken

Offline Carpenter84

  • Full Member
  • ***
  • Posts: 40
Re: From a machinist's box
« Reply #2 on: July 06, 2018, 08:47:03 PM »
Ya, looks like a gearbox shaft.
Logged

Offline slip knot

  • Sr. Member
  • ****
  • Posts: 95
Re: From a machinist's box
« Reply #3 on: July 06, 2018, 08:47:25 PM »
Looks like a jack shaft to me. two keywayed  slots for pulleys/sprockets and 2 bearing races. What it goes on is anyones guess.
Logged
Pages: [1]   Go Up
« previous next »