« previous next »
Pages: [1]   Go Down

Author Topic: looking for bit, don't know if it's made  (Read 4384 times)

0 Members and 1 Guest are viewing this topic.

Offline beachbumjeremy

  • Newbie
  • *
  • Posts: 1
looking for bit, don't know if it's made
« on: July 23, 2011, 09:43:19 PM »
I have an 18v dewalt impact, I love it. Problem is I can't use my 1 3/8 step bit with it. I don't believe they make an 1 3/8" step bit with a 1/4" shank, because I've spent hours looking to no avail. I thought I found one, but turns out it is a 3/8" hex quick change. So I'm looking for a bit that goes from 1/4" hex quick change to 3/8" hex quick change. Or an 1 3/8" stp bit with 1/4" shank.
Any help would be great
Logged

Offline Papaw

  • Owner/Administrator
  • Administrator
  • Hero Member
  • *****
  • Posts: 11221
  • Alvin, Texas
    • Papawswrench
Re: looking for bit, don't know if it's made
« Reply #1 on: July 23, 2011, 09:50:54 PM »
It is possible someone here has what you want, but did you notice that this forum is primarily concerned with old tools? Not much about battery operated tools.
Logged
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
 
 Flickr page- https://www.flickr.com/photos/nhankamer/

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: looking for bit, don't know if it's made
« Reply #2 on: July 24, 2011, 01:26:55 AM »
>Or an 1 3/8" stp bit with 1/4" shank.

Not exactly an old tool, but...

Any electrical supply place will have them, electricians use them. Home depot has slightly larger size made by Greenlee, may have the smaller size also, with the electrical tools....
Logged
Just a weathered light rust/WD40 mix patina.

Offline Lewill2

  • Hero Member
  • *****
  • Posts: 1987
  • Bucks County PA
Re: looking for bit, don't know if it's made
« Reply #3 on: July 24, 2011, 07:22:09 PM »
Sounds like using an impact is a poor way to use a step drill.
Logged

Offline 64longstep/Brian

  • Contributor
  • Hero Member
  • *****
  • Posts: 484
  • Phoenix Arizona
Re: looking for bit, don't know if it's made
« Reply #4 on: August 13, 2011, 04:48:53 AM »
Logged
If all else fails use a bigger hammer…
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
Pages: [1]   Go Up
« previous next »