Tool Talk

What's-It Forum => What's-It Forum => Topic started by: Neals on July 17, 2012, 05:35:49 PM

Title: ??W & CO
Post by: Neals on July 17, 2012, 05:35:49 PM

I should know this but am drawing a blank. Stamped on the end is ??W & CO. Below that is ?? USA. Also on the shaft is a triangle with an M inside or a W depending on which way you look at it. (Mossburg or Moore?) Sides on the M are straight not curved. Also marked 530. 3/8" x 1/2 " and 5 3/4 " long.

Title: Re: ??W & CO
Post by: lbgradwell on July 17, 2012, 05:46:24 PM

Any chance of a shot of the logo? Failing that, is it an M or a W when holding the 3/8" end up?

Title: Re: ??W & CO
Post by: Neals on July 17, 2012, 05:50:31 PM

Couldn't get a decent shot of the logo or stamping. With 3/8 end up its a W and the long side of the diamond is horizontal

Title: Re: ??W & CO
Post by: lbgradwell on July 17, 2012, 06:05:30 PM

Sounds like a JH Williams logo, but it doesn't look like a JH Williams wrench...

Don't you have a "macro" setting on your camera?

Title: Re: ??W & CO
Post by: rusty on July 17, 2012, 06:18:11 PM

Any chance the triangle / diamond has a T W in it?

Title: Re: ??W & CO
Post by: Neals on July 17, 2012, 10:29:20 PM

No T. Making is clear

Title: Re: ??W & CO
Post by: wvtools on July 17, 2012, 10:54:32 PM

It is a Williams set screw wrench.  The 1960 catalog has those sizes for the No. 530 double head set screw wrench.