Tool Talk
What's-It Forum => What's-It Forum => Topic started by: Mac53 on December 02, 2011, 11:10:06 PM
-
Any guesses? I'm at a complete loss.
(http://i79.photobucket.com/albums/j132/thehighlandsking/IMAG0596.jpg)
It has a ledge build in right under the screw plate on each side... So surely it mounted to something there... (http://i79.photobucket.com/albums/j132/thehighlandsking/IMAG0598.jpg)
-
I have seen much more elaborate ones that were in a very posh for its time (early 1900's) horse barn tac room. They were harness hangers as far as I know.
-
when I was young we had them in the horse barn usually two close together for one set of harness .
but that may not what they were made for originally. bob w.
-
That is one of the difficulties identifying old metal objects in barns. Farmers were very frugal, if a bracket broke off the carrage, it was likely to be screwed to the wall as a coat hook...
-
I have to agree with Rusty.......I also think it is just a make shift piece of cast, as the J part isn't deep enought for harness. Only would hold bridles or halters. The small cast peg just above the J in cast makes one think there was a cross piece that went there. Just another good what is it item.
-
I agree with Rudeawakening55. I doubt that it was designed as a harness hook. That said most anything could be used to hold harness/tack. We used large nails for our tack. Even that small hook could hold pony harness or maybe even buggy harness.