Tool Talk

Woodworking Forum => Woodworking Forum => Topic started by: lptools on December 06, 2024, 08:53:49 PM

Title: Stanley No. 2 and Stanley No. 12
Post by: lptools on December 06, 2024, 08:53:49 PM

I had both of these re-japanned by a friend . I cleaned up the milled faces and the steel and brass parts . The brass knobs are and handle screws on the No. 12 are correct replacements made by my b'in-law . The blade on the No. 12 is a new old stock Kunz. Everything else is original.

Title: Re: Stanley No. 2 and Stanley No. 12
Post by: Jim C. on December 08, 2024, 05:06:09 AM

Hey Lou, very nice restorations!  Do you have a project in mind where you’re planning to use them?  Looks like they’ll be around for another 100 years.  As I recall, coolford used to do some nice work restoring old planes.  It’s been some time since I’ve heard from him and I fear the worst. 

Jim C.

Title: Re: Stanley No. 2 and Stanley No. 12
Post by: lptools on December 09, 2024, 06:57:17 PM

Hello, Jim C. Thanks , nothing in the works , so they are in the collection for now. Coolford always had great items!!

Title: Re: Stanley No. 2 and Stanley No. 12
Post by: geneg on December 16, 2024, 06:30:26 PM

Great looking planes & look better than new.
What did the B.I.L. use to do the reeding on the brass knobs?  I hate to see them after someone used vise grips on them.  Knurling tool works, but doesn't look right.

Title: Re: Stanley No. 2 and Stanley No. 12
Post by: lptools on December 18, 2024, 10:50:09 AM

Thanks for the reply!  This is from my b'in-law ; I used a straight single pattern knurling die to cut the knurls . I then ground a piece of HSS with the appropriate radius to separate the knurls to match the original part.

Title: Re: Stanley No. 2 and Stanley No. 12
Post by: geneg on December 20, 2024, 04:07:46 AM

Thank you.  I have several cross pattern knurling tools, but haven't seen a straight single pattern one.  Now I know the proper name.  Reeding is the edge of a coin term.

Just found a bunch of them on ebay from another country.  They should be ok for brass.  I just need to measure the pitch of some of the chewed up knobs.