Tool Talk

General Category => General Discussion => Topic started by: lptools on March 26, 2017, 03:02:51 PM

Title: Frederick Tool & Engineering Corp. "Red E Nut" Nut Starters
Post by: lptools on March 26, 2017, 03:02:51 PM

Hello, I am trying to clear out the for sale items, one shelf at a time, and I came across this set. Frederick Tool & Engineering Corp., Electronics Manufacturers.  "Red E Nut" Nut Starters , for hex nuts ,sizes 2,4, 6,8, & 10. These are loaded by compressing the spring into the knurled cap, hex nuts are then placed on the guide pin. The handle is re-attached to the barrel, and when spring releases the hex nuts are forced against the plastic tip. Start the hex nut on the bolt, or stud, and tilt the barrel to release!!! Quite a contraption!!!!Regards, Lou

Title: Re: Frederick Tool & Engineering Corp. "Red E Nut" Nut Starters
Post by: Lewill2 on March 26, 2017, 04:11:40 PM

Now those look handy for assembly work.

Title: Re: Frederick Tool & Engineering Corp. "Red E Nut" Nut Starters
Post by: bonneyman on April 02, 2017, 11:36:17 AM

X2

Title: Re: Frederick Tool & Engineering Corp. "Red E Nut" Nut Starters
Post by: bill300d on April 02, 2017, 08:21:30 PM

I'll bet they work good for someone who is all thumbs too.