Tool Talk

Wrench Forum => Wrench Forum => Topic started by: HeelSpur on May 10, 2015, 07:13:31 PM

Title: John Warren Watson
Post by: HeelSpur on May 10, 2015, 07:13:31 PM

This was totally rusted when I found it all I could see is that there were letters on it.


(http://i1082.photobucket.com/albums/j368/wvabe/005_17.jpg)

http://www.classicandexotic.com/manuals/Watson_Stabilator_Manual.pdf

Title: Re: John Warren Watson
Post by: mvwcnews on May 11, 2015, 12:08:27 AM

Check the wrench end carefully.  The several I've seen over the years had a hex box end rather than open end -- so see if that one shows any signs of having been cut & ground off

Title: Re: John Warren Watson
Post by: HeelSpur on May 11, 2015, 06:18:53 AM

Quote from: mvwcnews on May 11, 2015, 12:08:27 AM

Check the wrench end carefully.  The several I've seen over the years had a hex box end rather than open end -- so see if that one shows any signs of having been cut & ground off

You're correct, just checked and it has been clearly cut off.
Wasn't even ground down to try to smooth out the cut lines.
Still pretty cool.
Thank you.