Tool Talk

What's-It Forum => What's-It Forum => Topic started by: p_toad on November 27, 2019, 07:38:37 PM

Title: i'll let you guess
Post by: p_toad on November 27, 2019, 07:38:37 PM

and then later i'll post another picture that will answer any questions.  hex shank and i found it in the dumpster  :undecided: :tongue:

Title: Re: i'll let you guess
Post by: lptools on November 28, 2019, 06:32:44 AM

Grommet tool?

Title: Re: i'll let you guess
Post by: EVILDR235 on November 28, 2019, 05:26:03 PM

Rivet setter ?


EvilDr235

Title: Re: i'll let you guess
Post by: p_toad on November 28, 2019, 07:52:03 PM

i should have put some scale in, but this look from abou 90 degrees from the other pic should answer it.

Title: Re: i'll let you guess
Post by: Bill Houghton on November 28, 2019, 10:04:45 PM

What distributor tool has that little slot?  Or is it a tire valve tool?

Title: Re: i'll let you guess
Post by: mikeswrenches on November 29, 2019, 06:35:59 AM

I’d go with "tire valve" tool.

Mike

Title: Re: i'll let you guess
Post by: lptools on November 29, 2019, 09:09:12 AM

I see the slot now, I would never have guessed tire valve tool, but I like it!!

Title: Re: i'll let you guess
Post by: p_toad on November 29, 2019, 07:12:39 PM

I'm guessing tire valve tool, too. (no evidence present, like a name stamp anywhere  :sad:).  Never seen one in this configuration before...have the valve caps with the tool built in and that marked Schrader brass tool (previously pictured here) as well as the "X" shaped tool.   

Title: Re: i'll let you guess
Post by: JoeCB on December 04, 2019, 10:49:50 PM

to be a tire valve tool there must be a bore in the end to accommodate the valve stem... is there a bore? And id the diameter correct?

Joe

Title: Re: i'll let you guess
Post by: p_toad on December 08, 2019, 06:18:49 PM

sorry those angles don't show the bore hole.   Yup, it's the correct size for valves!   :smiley: