Tool Talk
General Category => General Discussion => Topic started by: UncleBill on July 01, 2017, 02:52:36 PM
-
Well, according to the 1939 Plomb catalogue it is a No. 2110 Grease Bar. I can't read the font on the catalogue so if you have one please fill it in for what it is used for.
This is what I can make out from the catalogue
? like opening affect to clear obstructions and ? coarse teeth to prevent slipping. 28" long.
-
For greasing leaf springs?
-
open up the leaf springs so you could slop some grease in between so they didn't squeak as bad.
-
Here you go.......from the '40 cat.
-
I've had one for about 35 years ( not Plomb ). Use it as my go to pry bar. Just the right length.